The Ikea dishwasher is popular for those who want an affordable and effective dishwashing solution. However, like any appliance, it can encounter problems from time to time.
In this article, we’ll troubleshoot some of the most common Ikea dishwasher problems so you can get your dishwasher back up in no time.
If your IKEA dishwasher isn’t working properly, there are a few things you can do to troubleshoot the problem.
Troubleshoot IKEA Dishwasher
- Dishwasher Not draining properly:
If your dishwasher is not draining properly, the first thing you should check is the drain hose. Keep the hose in the correct alignment and ensure it is not kinked or blocked. There may be a faulty pump if the hose is clear.
Try resetting the dishwasher by turning it off and then on again. If the problem persists, consider getting a replacement.
- Tighten all Connections
First, check to ensure that all the connections are tight and that there are no water leaks.
Tighten all loose connections with a wrench. A loose connection will cause the dishwasher not to operate properly and can cause water damage.
- Check the Water Supply
Ensure that there’s enough water pressure and the water temperature is hot. The dishwasher will not operate properly if the water pressure is too low. The recommended water temperature is 120 Fahrenheit.
If the water temperature is too low, you can raise it by turning up the water heater. Maintaining an ideal water temperature will also save energy.
- Clean the Dishwasher
If your dishwasher is not doing its job properly, it is probably because it needs to be cleaned. With time, dishwashers tend to get clogged with food and grease.
Run a cycle with white vinegar or a commercial dishwasher cleaner to clean your dishwasher. To avoid these issues, make you read the instructions on the cleaner before using it.
- Replace Worn or Damaged Parts
If your dishwasher is still faulty after troubleshooting, you may need to replace some parts. Commonly replaced parts include the spray arm, wash impeller, and door seal.
You can purchase these parts at most hardware stores or online. Consult your dishwasher’s manual to find the right part for your model.
- Check the Drain Hose
The drain hose may be clogged if water leaks from your dishwasher. To clean the drain hose, disconnect it from the dishwasher and remove any debris blocking it. You can also use a plumber’s snake to clear the drain hose.
- Clean the Filters
If your dishwasher has filters, they may need to be cleaned. Depending on your dishwasher model, the filters are located in different places. Consult your manual to find the location of the filters.
To clean the filters, remove them and scrub them with a brush. If your dishwasher still isn’t working properly, you may need to replace the filters.
- Check for a Power Surge
If your dishwasher is not turning on, there may be a power surge. To check for a power surge, plug something else into the dishwasher’s outlet. If the other appliance does not work, there may be a power outage in your area.
- Check the Circuit Breaker
The circuit breaker tends to trip if there is no power surge and your dishwasher is still not turning on. To reset the circuit breaker, locate the breaker box and flip the switch for the dishwasher to the off position. Wait a while, and then turn the switch back on.
- Check Electrical Supply
If the circuit breaker is not the problem, there may be an issue with the electrical supply to the dishwasher. To check the electrical store, unplug the dishwasher and turn off the power to the outlet.
Next, remove the access panel to the dishwasher. Locate the wire connections and make sure they are secure.
Tighten any loose connections with a wrench. Finally, turn the power back on and plug in the dishwasher. If it still does not work, you may need to call an electrician.
To Prevent these issues:
- Tighten all connections before each use
- Check the water supply regularly
- Clean the dishwasher regularly
- Replace worn or damaged parts as soon as possible
- Check the drain hose for clogs
- Clean the filters regularly
- Check for power surges
- Reset the circuit breaker if it is tripped
- Check the electrical supply monthly
