If the IKEA dishwasher starts flashing, this usually indicates that there is a problem with the water supply. Check to ensure the water supply is on, and there is enough pressure.
If the dishwasher is still flashing, call a qualified technician for assistance if the tips mentioned below don’t solve the issue.
Why Does The IKEA Dishwasher Starts Flashing?
- Check the Power Supply:
If your IKEA dishwasher starts flashing, there are a few things you can do to troubleshoot the problem. Begin with checking to see if the dishwasher is properly plugged in.
If the dishwasher is plugged into a GFI outlet, ensure that the reset button is pushed in.
- Check the Water Supply:
If the power supply is being adequately supplied, then the next thing you should check is the water supply. Make sure the water supply valve is continuous all the way and that there is adequate water pressure.
In case the water pressure is too low, the dishwasher will not be able to operate properly.
- Adjust Correct Water Pressure:
If the water pressure is lower than usual, you will need to adjust the amount of water supplied to the dishwasher. Consider turning the water supply valve clockwise until it stops.
- Check Water Temperature:
Another reason why your IKEA dishwasher may start flashing is if the water temperature is not hot enough. The water should be at least 120 degrees Fahrenheit for the dishwasher to operate properly.
If the water temperature is not hot enough, you can try running the hot water faucet until the water is hot. To fix this issue, make sure you adjust the water heater setting to a stable temperature.
- Clean the Inlet Screen:
If the dishwasher is still flashing after you have checked the power supply, water supply, and water temperature, something is likely blocking the water inlet screen.
This screen is located where the water hose attaches to the dishwasher. To clean the inlet screen, remove the hose from the dishwasher and use a brush or toothpick to remove any debris blocking the screen.
- Replace the Inlet Valve:
If the inlet screen is clear and the dishwasher is still flashing, the problem may be with the valve. This valve is located behind the inlet screen. To replace the inlet valve, you must shut off the water supply and disconnect the water hose from the valve.
Then, remove the screws that hold the valve in place and replace them with a new one.
- Check the Drain Hose
Another possible reason your IKEA dishwasher may start flashing is that the drain hose is clogged. Clear the drain hose of any obstructions. If the drain hose is clogged, use a plunger to try and clear the obstruction.
- Run a Test Cycle
You should run a test cycle if you have checked all the above and the dishwasher is still flashing. To do this, press and hold the start button for 5 seconds. This will start a test cycle that will help to diagnose the problem.
If the dishwasher is flashing after you have checked the power supply, water supply, and water temperature and cleaned the inlet screen, there is likely a problem with the dishwasher itself.
It is advisable to contact a qualified technician for assistance if this is the case.
How to Prevent this issue?
A few things can be done to prevent this issue from happening:
- Ensure the dishwasher is properly plugged in and the power supply is turned on.
- Check the water supply to ensure adequate pressure and that the water temperature is hot enough.
- Clean the inlet screen and replace the inlet valve if necessary.
Conclusion:
– If your IKEA dishwasher starts flashing, there are a few things you can do to troubleshoot the problem.
– Check if the dishwasher is properly plugged in and the power supply is turned on.
– Next, check the water supply to ensure adequate pressure and that the water temperature is hot enough.
– Finally, clean the inlet screen and replace the valve if necessary.
– If the dishwasher is still flashing after you have checked all of these things, there is likely an issue with the dishwasher itself, and you will need to call a qualified technician for assistance.